注意报错提示：
" ~1 M- H5 b1 c: ~1 p& ^- G646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.9 [) b/ F2 _) [2 u0 D2 G
646.04: Travel action ignored.
4 |6 U. Y ~% @) Q0 Q) E7 l$ O646.04: No debugger information is available.
1 P6 b' s n: z8 H: A1 O646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.7 ~% ]; r2 i6 U& X; b# J
646.04: Travel action ignored.
# z3 _$ M4 e& O5 v0 N646.04: No debugger information is available.3 E% X4 Y T& D+ ^ Q* X
. v+ s" w: _# c3 h
回来看代码：
* t( ?% ~( N7 e" v
9 _, u# l- k. E$ ^3 |9 wbegin P_output1 arriving procedure" W0 |) `( d% }( W) p1 |) l
travel to Conv.staoutput1
; Y- k* {& T/ F move into Q_output(1)
/ ~& F2 o; ]$ Y0 I% a /*Location to wait for a vehicle*/9 q; M5 ]. m, H( R0 |( @: T
travel to Rgv.cpoutput1 /*Get on Vehicle*/9 e4 G- p+ w5 ^
send to P_store
4 L& C1 D' P, r9 V8 Kend
- y6 L$ ~" k! K9 S
( I. z" y! ~8 A6 P5 K! vbegin P_store arriving procedure1 S' }6 F' h: C
travel to Rgv.cpstore, j/ A1 h* D* ^( ?
/* Travel onboard vehicle to cpstore */
/ x9 Q- I i5 E- ?9 Y" Y( H move into Q_store /* Get off vehicle */
8 N0 I n2 K2 n9 h wait for 20 sec& m, I6 T2 u( w2 C! a5 y# l
set A_Time to ac - A_Time$ Q3 _; j) T' G% p( n* F
print this load, "Time in system " A_Time to message
7 |& Q H. y% L$ l, s! v+ j inc V_Numdone by 1, j# z0 E) ~: n. d0 u- u$ W. o+ O
send to die
* Z& Y, S2 e& P6 Hend
& j* }& G" j4 T ~5 Q; Z7 `- {7 `. Q) w2 a( T1 P/ Q Z7 B. E* `7 U
知道怎么改了吧？ |
发表于 2009-7-15 21:45:44
