注意报错提示：
* m( S$ H; v5 }7 L. _( m% {! s646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
; O" A: N0 r" U1 Y646.04: Travel action ignored.
6 }# f2 g1 e Q4 Z646.04: No debugger information is available.
" P( q4 P% d* ]. q! L' l646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.: `0 R8 L' c6 ^0 Z7 e
646.04: Travel action ignored.
9 k+ F% Z2 j; q$ V. Y& L j646.04: No debugger information is available.' o! U- j1 `" ]5 H" c N* @( {2 B
$ U0 V- O) |$ ] @+ p
回来看代码：
7 M# C9 L! [' e# p! Y/ ~6 q2 Z! y t) b1 I6 o( ]
begin P_output1 arriving procedure
* v' ?0 S/ }& X2 R$ {" \, \# y9 _ travel to Conv.staoutput1) u' s2 i4 K7 S% \; k
move into Q_output(1) ( O! X5 w, K( E0 K" P# k
/*Location to wait for a vehicle*/
) R& r/ r$ `( I/ x2 f- Y! ^ travel to Rgv.cpoutput1 /*Get on Vehicle*/
' K# v" f, K ?5 D+ e send to P_store
" d: Y2 N3 u8 Nend
0 K5 l; w" N R0 [! X7 R
6 k: E9 q/ Z, I0 V0 jbegin P_store arriving procedure+ E: r5 ]7 z) L& |
travel to Rgv.cpstore) q+ l! t3 i& E) I
/* Travel onboard vehicle to cpstore */
& _3 C) a6 W* V3 M7 z move into Q_store /* Get off vehicle */! c% s$ z5 Y8 u
wait for 20 sec
" z4 q" b' x5 }, f set A_Time to ac - A_Time
- h) R/ K+ |8 Y% W- Y- J2 d print this load, "Time in system " A_Time to message9 ` h4 K" ~1 B u; f0 A- q
inc V_Numdone by 1
p2 [9 Z8 V/ G7 i+ T) `- y send to die
% b I2 J; C9 z ?- n6 V: Eend8 ^% R& a+ t ~4 J" N/ P
& u8 F1 o. A+ K. J Z: J- y% e% e知道怎么改了吧？ |
发表于 2009-7-15 21:45:44
