求解

am_simulation

RGV在Q_wait1-6取载后在8个工作站净空、lable
8 f8 L5 _0 P+ o: b. Q最后在空箱在Q_store流出
目前run model结果发现，货物淤塞在staoutput1-8
7 B. w3 V/ h  A% S8 `9 r% X/ t未能流出，求解

zhdew

注意报错提示：
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
646.04: Travel action ignored.
% W" v, _  b% ]1 ~# S3 A646.04: No debugger information is available.
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
! a4 U& a. V0 u# q646.04: Travel action ignored.
646.04: No debugger information is available.
  ~1 U8 v, z7 G7 Y8 c
2 t1 ]5 l- y. ^0 j$ ]回来看代码：

begin P_output1 arriving procedure
   travel to Conv.staoutput1
8 s% \1 E" H3 ~  A' X. ?# E4 A   move into Q_output(1)
   /*Location to wait for a vehicle*/
6 H! R' j- J0 p: d4 _' S    travel to Rgv.cpoutput1 /*Get on Vehicle*/
( \: Z% k7 |5 z& r   send to P_store
7 h: D. E' k9 y; D- }end  
7 b* x6 S( h9 u1 s- N
. B0 Z% e4 F- ~% T) f- sbegin P_store arriving procedure
" y5 r+ T3 Z. f; J# v8 ?7 H9 X   travel to Rgv.cpstore
   /* Travel onboard vehicle to cpstore */
! ^/ l, _0 f( i" S3 e6 b" E- m! R   move into Q_store /* Get off vehicle */
   wait for 20 sec
   set A_Time to ac - A_Time
- ^/ S3 Z+ ]% `4 |   print this load, "Time in system " A_Time to message
   inc V_Numdone by 1
  b7 N2 m) h( U, n6 }" w   send to die
5 q) n1 o1 s$ |end

8 d7 s; p2 u9 g, ?- e知道怎么改了吧？