注意报错提示：
+ x% G9 c9 W7 A! L646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
% t/ j9 e8 L8 J% i- Q9 C646.04: Travel action ignored.& Y- l' @7 g6 c2 t% |
646.04: No debugger information is available.
e1 O) S7 S; E* w$ B" e7 i1 O" w646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
- Q4 C6 L \; T/ T! H/ ]& T646.04: Travel action ignored.( [ s4 s9 G+ R; g- {( ~, P0 z
646.04: No debugger information is available.7 e3 n( C' i# r0 P" }/ G
* @4 _) v$ {$ k$ L5 Z' ?0 t
回来看代码：
* c2 _. G+ y* S) G2 t. E- W0 W4 Z H1 U* }: F
begin P_output1 arriving procedure. ]' k" [* {" l) I+ o1 S# q
travel to Conv.staoutput1
/ X* S5 v: ?6 t& e( ~ move into Q_output(1)
7 V% T& h3 @5 `5 g. `! V /*Location to wait for a vehicle*/
' F+ M" A5 J4 X4 y i- G2 F travel to Rgv.cpoutput1 /*Get on Vehicle*/1 m3 o& I4 _( n% l( I2 i
send to P_store
. P7 Y1 T9 Z- [4 ?) Y9 C& yend / y+ s6 X; Q6 a! s8 A/ v5 J
! k( I/ ?7 g; E' s0 H& Q" Jbegin P_store arriving procedure7 T, Z, o$ i0 b) Z$ K' Z, C7 B3 D- B D2 S: _
travel to Rgv.cpstore
" L1 A4 q/ l- C& E) W& \+ Y+ j /* Travel onboard vehicle to cpstore */6 _" k; M) _9 G7 ?+ P( }: ~5 k
move into Q_store /* Get off vehicle */8 n; O/ {. B; g* W6 ?, [
wait for 20 sec
, Q0 j4 O7 ^* Y% ?- _$ S8 T set A_Time to ac - A_Time
/ k& v3 [. T% Y& |- U* g# {! j print this load, "Time in system " A_Time to message
$ ~1 S* F! A/ l inc V_Numdone by 1
+ S6 O; G' R+ g9 ^1 Z send to die8 G' P; T" A& X- O# @
end' l2 R. s& G: K
2 U0 \/ U4 f$ E- S" |知道怎么改了吧？ |
发表于 2009-7-15 21:45:44
